双钳口自动校准平行i气动钳夹 (DH系列)
• 具有可选弹簧的双动作（正常关闭和正常启动）。
• 长行程或者短行程(1)。
• 可以使用通孔螺丝进行前紧固(2)。
• 动力传动效i率高(1)。
• 可选电磁式或电感式的传感器(3)。
• FDA-H1 食品级润滑脂。
2-jaw self-centering pneumatic parallel gripper
(series DH)
• Double acting with optional springs (normally closed or
normally open).
• Long stroke or short stroke (1).
• P05sibility of front fastening with through screws (2).
• High efficiency force transmission (1).
• Optional magnetic or inductive sensors (3).
• FDA-H1 food-grade grease.
3-jaw self-centring electric gripper
• Plug & p1ay user friendly gripper.
• No electricity con5umption when gripper is engaged.
• No programming required.
• Gripper retention guaranteed in event of blackout.
• Self Adapting jaws part.
• Long life Brushless motor (Brushless DC).
• Built-in motor driver.
• 24 Vdc Low Voltage Power Supply.
• M8x1, 3 poles standard connection.
• Controllable by PLC as a pneumatic valve.
• Fiber-carbon gear reduction.
• 10 milion cycle maintenance-free.
• T-slot style jaws for heavy loads.
• Weight-dimensi0n5-force best trade off.
• Rotary actuator fitting compatible.
• Optional magnetic sensors.
编程单个SB8F
在对传感器盒进行编程之前，请确保有线输入处于所需配置（开/关）以启用输出。按下AUTOSET按钮并按住3秒钟，直到READING红灯开始闪烁，然后松开。红灯（READING）闪烁表示微处理器正在读取和存储全部输入的状态。然后红灯熄灭，启用了输出。黄灯（STORED）指示启用输出。
Before programming the sensor box, make sure that the wired inputs are in the confguration (ON/OFF) desired to enable the output. Press the AUTOSET button and hold it down for 3 seconds until the READING red light starts fashing, then release it.The red light (READING) fashing indicates that the microprocessor is reading and storing the state of all the inputs. Then the red light goes off and the output is enabled. Output enabling is indicated by the yellow light (STORED).
以上信息由专业从事三爪抓持器的吉玛泰克于2025/4/8 22:59:31发布
转载请注明来源：http://benxi.mf1288.com/jmtkzdh-2854144094.html
上一条：本溪光泽度仪品牌服务为先「多图」
